Love My Libre armbands are reusable and last months, and sometimes years, depending on how you use them. Unlike stickers and patches, there's nothing sticky on your skin, so it's totally up to you when you wear yours: for everyday style, or for showering, swimming and sport.

Ben fitting a Love My Libre armband over the FreeStyle Libre sensor on his upper arm

How to fit your Libreband or Dexband

Fitting takes a minute or two the first time. After that, it simply slides on and off.

Your first fit

  1. Slide it on. Slide (or “walk”) the armband up your arm, then gently lift it so the cover sits fully over your sensor. A second pair of hands can make this easier.
  2. Set the size with the slider. Pull the strap through the plastic slider until the armband fits comfortably around your upper arm: secure enough that it won't slip, without being too tight. It may take a couple of tries to get it just right.
  3. Fine-tune with the VELCRO®. Close the VELCRO® to hold the armband in place. It's there to secure the fit, not to set the size, so there's no need to pull it tight. The strap isn't elastic.

Every time after that

Once it's sized, leave the slider and strap as they are. Just slide the armband up your arm and lift the cover over your sensor. To take it off, carefully lift the cover off your sensor, then slide the armband back down.

How to tell it fits well

  • It stays in place and doesn't slip down your arm.
  • It feels comfortable, not tight.
  • The VELCRO® closes neatly: not too short, and not flapping.

Arm size can change slightly through the day and in different conditions and climates, so a small VELCRO® adjustment now and then is normal. Just unfasten it, re-fasten, and you're set.

Fitting diagrams

These diagrams showing the slider and VELCRO® adjustments are also printed on the back of the “Your Libreband” card in your packaging.

Love My Libre fitting information card: adjust the size by gently pulling the fabric through the plastic slider, then position the armband over the sensor and secure it with the VELCRO® fastener

Caring for your armband

  • Wash your armband gently with soap and water. Avoid scrubbing the strap.
  • If your armband comes into contact with chlorinated or salt water, rinse it in fresh water afterwards.
  • After washing, rinsing, showering or swimming, gently pat the strap dry with a towel.
  • Let it dry fully before you put it away.

Precautions

In rare cases, people with very sensitive skin may experience irritation, itching or a rash. If this happens, remove your armband and speak to your healthcare team if it continues.

Need help with fitting? Get in touch and we'll be happy to help.